Arris C4C - Configure Cable Modem Remote-Query Source-Interface

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1391
configure cable modem remote-query source-interface
Purpose
Configures the cable modem SNMP remote query settings to allow query of the specified interface.
Default Access Level
15
Command Syntax
configure cable modem remote-query source-interface {cable-mac <mac> | gigabitethernet <slot/port> |
link-aggregate <0-9[0.254]> | link-aggregate <0-9[.0-254]> | loopback <0-15> | tengigabitethernet
<slot/port>}
configure cable modem remote-query source-interface {cable-mac <mac> | gigabitethernet <slot/port> |
link-aggregate <0-9[0.254]> | loopback <0-15> | tengigabitethernet <slot/port>} no
Supplemental
Information
To turn off remote query settings, use the no version.
Parameters
cable-mac <mac>
The MAC identifier <mac>
gigabitethernet
<slot/port>
RCM slot number/gigabitethernet port number. Valid value is <17-18>/<0-9>
link-aggregate >
0-9[0.254]>
Link-aggregate identifier.
loopback <0-15>
Loopback interface number
tengigabitethernet
<slot/port>
RCM slot number/tengigabitethernet port number. Valid value is <17-18>/<10>