Arris C4C - Configure Cable Fiber-Node Cable-Mac Load-Balance Init-Technique

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1269
configure cable fiber-node * cable-mac * load-balance init-technique
Purpose
Sets the initialization technique for a general load-balance group for the specified fiber-node.
Default Access Level
15
Command Syntax
configure cable fiber-node <fn_name> cable-mac <mac> load-balance init-technique [unicast-ranging]
[reinit-mac] [broadcast-ranging] [ranging] [direct] [disable]
configure cable fiber-node <fn_name> cable-mac <mac> load-balance init-technique [unicast-ranging]
[reinit-mac] [broadcast-ranging] [ranging] [direct] [disable] no
Supplemental
Information
To disable the initialization technique, use the no option.
Parameters
<fn_name>
Fiber node name up to 16 characters long
<mac>
The MAC identifier (0-415 or slot/mac).
[unicast-ranging]
Performs ranging on the new channel before normal operation.
[reinit-mac]
Reinitializes the MAC
[broadcast-ranging]
Performs broadcast initial ranging on the new channel before normal operation.
[ranging]
Performs either unicast or broadcast ranging on the new channel before normal operation.
[direct]
Uses the new channel(s) directly without re-initializing or ranging.
[disable]
No load balancing will be done for this group (all bits set to 0).
Related Commands
show cable load-balance group (page 2663)