Arris C4C - Configure Cable Load-Balance Rule Disable-Period

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1350
configure cable load-balance rule * disable-period
-Purpose
Sets the time for a rule to be disabled based on time of day.
Default Access Level
15
Command Syntax
configure cable load-balance rule <1-4294967295> disable-period [start-time <sec-since-midnight |
hr:min[:sec]>] [period <secs | hr:min[:sec]>]
configure cable load-balance rule <1-4294967295> disable-period [start-time <sec-since-midnight |
hr:min[:sec]>] [period <secs | hr:min[:sec]>] no
Supplemental
Information
To remove the disable period, use the no option.
Parameters
<1-4294967295>
Rule number
sec-since-midnight
Seconds elapsed since midnight. Valid range is 0-86400.
hr:min[:sec]
Military time for hours, e.g 0-23
secs
Length of time in seconds that load balancing is disabled. Valid range is 0-86400
hr:min[:sec]
Military time for hours, e.g 0-23
Related Commands
configure cable load-balance policy (page 1346)