Arris C4C - Configure Route-Map Permit Set Ip Next-Hop

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2289
configure route-map * permit * set ip next-hop
Purpose
Configures where the next-hop to send packets that match the specified route-map.
Default Access Level
15
Command Syntax
configure route-map <word> permit [<int>] set ip next-hop <a.b.c.d>
configure route-map <word> permit [<int>] set ip next-hop [<a.b.c.d>] no
Supplemental
Information
To return to the default setting, use the no option.
Parameters
<word>
Name of this route-map
[<int>]
Sequence number
<a.b.c.d>
IPv4 or IPv6 address of the next hop