Arris C4C - Configure Cable Load-Balance General-Group-Defaults Init-Technique

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1340
configure cable load-balance general-group-defaults init-technique
Purpose
Configures the general groups load-balance default values.
Default Access Level
15
Command Syntax
configure cable load-balance general-group-defaults init-technique <broadcast-ranging | direct | disable
| ranging | reinit-mac |unicast-ranging>
configure cable load-balance general-group-defaults init-technique [<broadcast-ranging | direct |
disable | ranging | reinit-mac |unicast-ranging>] no
Supplemental
Information
To remove the general groups load-balance default values, use the no option.
Parameters
broadcast-ranging
Perform broadcast initial ranging on a new channel before normal operation
direct
Use the new channel(s) directly without re-initializing or ranging
disable
No load balancing will be done for this group (all bits set to 0)
ranging
Perform either broadcast or unicast ranging on new channel before normal operation
reinit-mac
Reinitialize the MAC
unicast-ranging
Perform unicast ranging on new channel before normal operation.