Arris C4C User Manual

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1966
configure interface tengigabitethernet * ip address
nPurpose
Creates the virtual interface and assigns the IP address and mask of the virtual interface associated with the default route.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip address <ip addr> <mask> [secondary]
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip address [<ip addr>] [<mask>]
[secondary] no
Supplemental
Information
To deletes a virtual router interface from the specified virtual router, use the [no] option of the command. All primary and secondary
IP addresses for the interface are also deleted if a [secondary] is not specified. If a [secondary] is specified, then only the secondary
IP address/mask is deleted and the virtual interface remains.
Note: Some subnets are reserved for CMTS Internal Processor Communications (IPC). No interfaces may be configured for the
following subnets:
100.0.0.x 100.0.1.x 100.0.2.x
1.1.0.x 1.1.1.x
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<ip address>
The IP address of the interface
<mask>
The IP mask associated with the interface
[secondary]
Secondary IP address or mask

Arris C4C Specifications

General

Brand	Arris
Model	C4C
Category	Control Unit
Language	English