Arris C4C - Configure Ipv6 Neighbor Cable-Mac

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2115
configure ipv6 neighbor * cable-mac
Purpose
Creates or deletes a static entry in the neighbor discovery (ND) cache for a cable-mac interface using the MAC address.
Default Access Level
15
Command Syntax
configure ipv6 neighbor <ipv6 address> cable-mac <mac[.0]> <mac-address>
configure ipv6 neighbor <ipv6 address> cable-mac [<mac[.0]>] [<mac-address>] no
Supplemental
Information
To remove the neighbor, use the no option.
Parameters
<ipv6-address>
The address of the neighbor. It is in hexidecimal using 16-bit values between colons.
<mac[.0]>
The MAC domain number (valid numbers are 0-1)
<mac-address>
The 48-bit ethernet address used to address the node on the interface.