Arris C4C - Configure Cable Intercept Subscriber MD Udp until

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1323
configure cable intercept * subscriber * md * udp * until
Purpose
Creates a Legal Intercept Tap session for an individual subscriber.
Default Access Level
15
Command Syntax
configure cable intercept [userid <id>] [password <password>] subscriber <mac> [<emable | disable>]
[userid <id>] [password <password>]md <ip_addr> udp <port> [tos <value>] [until <time>]
configure cable intercept [userid <id>] [password <password>] subscriber <mac> [<emable | disable>]
[userid <id>] [password <password>]md <ip_addr> udp <port> [tos <value>] [until <time>] no
Supplemental
Information
The new LI tap session is enabled by default unless the disable keyword is explicitly given. Only one LI tap session is permitted per
CM and subsequent attempts to create an LI tap session will be rejected unless the current tap session is deleted first.
Note: When an LI tap session is first created, the md, udp, and until keywords must be present. The tos keyword is optional and will
default to 0x22 if not provided.
To remove the LI tap session for a specified subscriber, use the no option.
Parameters
[userid] id>
SNMP User ID
[password
<password>]
SNMP Authentication Password
<mac>
Subscriber’s MAC address. Valid forms for a MAC address are:
xx.xx.xx.xx.xx.xx
xxxx.xxxx.xxxx
xxxxxxxxxxxx
<ip_addr>
IP address of the mediation device.
<port>
UDP port. Valid range is 1-65535.
[tos <value>]
The TOS keyword is optional and may be used to override the default TOS byte of 0x22 for the UDP/IP encapsulation.
<time>
Expiration date for the LI tap session. The hh:mm time value of the until keyword is optional and defaults to 23:59