Arris C4C - Сonfigure Interface Cable-Mac Isis Hello-Interval

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1680
configure interface cable-mac * isis hello-interval
Purpose
Computes the hello interval based on the hello multiplier so that the resulting hold time is 1 second.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac[.s]> isis hello-interval <10-600000> [minimal] [minimal <level1 |
level2>]
configure interface cable-mac <mac[.s]> isis hello-interval [minimal] [minimal <level1 | level2>] no
Supplemental
Information
N/A
Parameters
<mac[.s]>
The MAC identifier and optional sub interface.
<10-60000>
Specifies the milliseconds between hello packets (before multiplier)
[minimal]
Sets the interval to one second/multiplier.
[minimal <level1 |
level2>]
Specifies the type of adjacencies to be formed on this interface. If no value is specified, then modify value for both level-1 and level-
2.