Arris C4C - Configure Cable Intercept

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1321
configure cable intercept
Purpose
Places the CLI into config-cable-intercept mode.
Default Access Level
15
Command Syntax
configure cable intercept [userid <id>] [password <passward>]
Supplemental
Information
This mode allows the operator to efficiently enter multiple tap session configurations in a single modal session and is exited via the
exit command.
Note: All local access to the configure cable intercept and show cable intercept commands is secured by the same userids
and authentication passwords that are used for SNMPv3 access. This includes read/write permission levels associated with the
userids. If the userid and authentication password are not provided on the command line, then the CLI will prompt for them.
Parameters
<userid>
SNMP User ID. Note that no spaces are allowed in the user ID.
<password>
SNMP Authentication Password.
Related Commands
show cable intercept (page 2658)