Arris C4C - Configure Ipv6 Dhcp Relay Source-Interface

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2100
configure ipv6 dhcp relay source-interface
Purpose
Configures the interface to be used for the SIP field.
Default Access Level
15
Command Syntax
configure ipv6 dhcp relay source-interface {cable-mac <mac[.0]> | gigabitethernet <17-18>/<0-9> | link-
aggregate <0-9[.254]> | loopback <0-15> | tengigabitethernet <17-18>/<0-9>}
configure ipv6 dhcp relay source-interface {cable-mac [<mac[.0]>] | gigabitethernet [<17-18>/<0-9>] |
link-aggregate [<0-9[.254]>] | loopback [<0-15>] | tengigabitethernet [<17-18>/<0-9>]} no
Supplemental
Information
To remove the interface, use the no option.
Parameters
<access-list name>
The chosen name for the access-list. Note that the user must not be able to configure with CLI an IPv6 ACL by specifying an ACL
number (as is permitted with IPv4 standard and extended ACLs). However, an internally generated number will be assigned to the
ACL in the range 200 to 399.
<mac[.0]>
The MAC identifier.
<17-18>/<0-9>
RCM slot number/gigabitethernet port number [.subinf number]
<0-9[.254]>
Link aggregate
<0-15>
Loopback interface number
<17-18>/<10>
RCM slot number/tengigabiteithernet port number [.subinf number]
<seq-start>
The index for the starting entry in the ACL.
<increment>
The increment amount between entries in the ACL.