Chapter 32: Packet Throttling
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 937
configure cable proto-throttle max-burst 6
Clear CM Throttling Counts
To clear all cable modem throttling counts and information, whether or not any modems or CPE have been throttled, use
the following command:
clear cable proto-throttle history
Clear All Proto-Throttle Counters
To clear all cable-side proto-throttle counters, use the following command:
clear cable proto-throttle counters
Determine Cable Throttling Status
Use the following command to determine cable throttling status:
show cable proto-throttle
An output similar to the following example will occur:
ARP throttling is: off
DHCP throttling is: off
DHCPv6 throttling is: off
IPv6 ND throttling is: off
max-burst: 10
interval: 5
Drop Counts:
Interface DHCP ARP ND DHCPv6
------------------------------------------------------------------------------------------------
cable-upstream 3 0 0 0 0
Determine CM or CPE Throttling
Use the following command to determine if a CM or CPE is being throttled:
show cable modem detail
An output similar to the following example will occur:
Nov 05 12:31:34
13/0/0-5/0/0 CM 0013.0000.0001 (00.13.00) D3.0 State=Operational D1.1/atdma PrimSID=1 FiberNode=
To Next Page
Loading...
Need help?
General
