Arris C4C - Configure Route-Map-Policy Permit Set Ip Recursive-Next-Hop

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2320
configure route-map-policy * permit * set ip recursive-next-hop
Purpose
Sets a recursive next-hop IP address.
Default Access Level
15
Command Syntax
configure route-map-policy <name> permit [<int>] set ip recursive-next-hop <word>
configure route-map-policy <name> permit [<int>] set ip recursive-next-hop [<word>] no
Supplemental
Information
To remove the recursive next-hop IP address, use the no option.
Parameters
<name>
Name of this route-map
[<int>]
Sequence number
<word>
IPv4 or IPv6 address