Arris C4C - Show Cable Dsg Tunnel Classifier

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2646
show cable dsg tunnel * classifier
Purpose
This command displays the tunnel classifier information.
Default Access Level
1
Command Syntax
show cable dsg tunnel <tunnelid> classifier [<classid>]
Supplemental
Information
If the optional classifier is used, this command will display the tunnel classifier information
Note: If the tunnel that a classifier is associated with does not contain provisioning, then the tunnel will be preceded by an asterisk
(*). If you see a plus symbol (+), means the source network looked up from a qualified domain name.
Parameters
<tunnelid>
Tunnel ID associated with the classifier. Valid values are 1 to 65535.
[<classid>]
Valid values for classId are 1 - 65535.