Arris C4C - Configure Packetcable Dqos Timer

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2211
configure packetcable dqos timer
Purpose
Sets the Packetcable DQoS (Dynamic Quality of Service) timer.
Default Access Level
15
Command Syntax
configure packetcable dqos timer <t0 |t1> [time]
configure packetcable dqos timer <t0 |t1> [time] no
Supplemental
Information
N/A
Parameters
<t0 | t1>
Where timer name is "t0" or "t1" without the quotes.
t0 - limits the amount of time between the reception of a Gate-Alloc message and a Gate-Set message for the same DQoS Gate. The
default value of this timer is 30 seconds. This timer has a range of 1-60 seconds.
t1 - limits the validity period for authorization of a particular PacketCable call. This timer is started whenever a Gate is established
and reset whenever a Commit operation is performed on the resources authorized by the gate. Ordinarily, Timer-T1 is received in
the Gate-Set message. If the value given in the Gate-Set message is zero, the Timer-T1 will be set to a provisioned value. The default
value of this timer is 250 seconds. This timer has a range of 1-600 seconds.
[time]
Timer range value.