Arris C4C - Routing Update Management; Enabling RIP on the C4;C CMTS; Disabling RIP on the C4;C CMTS; RIP Enable and Disable

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 522
Routing Update Management
The following applies as regards to the management of routing updates:
 Entries in the RIP routing tables are dynamically updated as needed.
 As the topology of a network changes, some routes will become invalid.
 RIP uses "aging" algorithms to eliminate invalid routes from its tables.
RIP Enable and Disable
The following RIP-related enable and disable tasks, along with their associated commands, are grouped for convenience.
This is not intended to be a step-by-step procedure.
Enabling RIP on the C4/c CMTS
By default, RIP is disabled on the C4/c CMTS.
Enter the following command to enable RIP:
configure router rip shutdown no
The system will respond:
RIP has been enabled
Validate RIP status:
show ip vrf
Virtual Router Details:
Name Index OSPF RIP ISIS BGP ICMP-TIME-EXCEEDED
=============== ========== ==== === ==== === ==================
default 1 no yes no no no
Disabling RIP on the C4/c CMTS
Use the following command to disable RIP:
configure router rip shutdown
The system will respond: