Arris C4C - Configure Arp State Searching Cable Broadcast

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1236
configure arp state searching cable broadcast
Purpose
This command controls whether broadcast ARP packets can be sent for an IPv4 address where the CMTS has no stored knowledge
about a MAC/IP binding.
Default Access Level
15
Command Syntax
configure arp state searching cable broadcast
configure arp state searching cable broadcast no
Supplemental
Information
The total number of broadcast ARPs to send before switching to the not-present state is also limited by the configure arp state
searching max-number command. If broadcast for unknown MAC/IP bindings is disabled, the broadcast ARP entry will transition
immediately to the not-present state. This command sets the cadAgingArpCacheSearchingCable-Broadcast MIB to true (which is the
default value)
To reset the value to false, use the no option.