Arris C4C - Configure Access-List Igmp

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1201
configure access-list * igmp
Purpose
Configures an extended Access Control List (ACL) on the CMTS if the protocol value is IGMP.
Default Access Level
15
Command Syntax
configure access-list {<100-199> | <name>} <1-2147483647> <permit | deny | remark | resequence> igmp
<src-ip> <dst-ip> [dscp <0-63>] [precedence <uint>] [tos <0-15>] [fragments] [<igmp-type>]]
configure access-list {<100-199> | <name>} <1-2147483647> <permit | deny | remark | resequence> igmp
<src-ip> <dst-ip> [dscp <0-63>] [precedence <uint>] [tos <0-15>] [fragments] [<igmp-type>] no
Supplemental
Information
To remove an extended ACL, use the no option.
Parameters
<100-199>
The extended ACL numeric identifier of the access list.
<name>
Access list name
<1-214748364>
Access list index number.
<permit | deny |
remark |
resequence>
permit: Permits access if the condition is matched.
deny: Denies access if the condition is matched.
remark: Access list entry comment
resequence: Resequence the access list index numbers
igmp-type
If the protocol value is IGMP.
<src-ip>
This can be the {host <IP> | any | <IP> [mask]}
<dst-ip>
This can be the {host <IP> | any | <IP> [mask]}
[dscp <0-63>]
Match packets with given DSCP value. Valid values are: