To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

show access-list

Purpose

Displays the configured ACLs.

Default Access Level

Command Syntax

show access-list [<access-list-number>]

Supplemental

Information

By default, all ACLs are displayed. If an access-list-number is given, this command will only show that ACL entry

Note: ‘any’ indicates a source-ip of 0.0.0.0 and wildcard of 255.255.255.255; the displaying of the wildcard is omitted if it is 0.0.0.0.

Because of software limitations, the show access list command returns null results for match counts for some operations. These

operations are related to configuring router distribution lists, redistribution, and SNMP community strings. See the list below.

The various forms of the commands listed below do not update the match counts for any ACLs associated with the interfaces

affected by these commands:

configure router ospf [vrf <name>] distribute-list …

configure router ospf [vrf <name>] redistribute …

configure router rip redistribute rip

configure router rip [vrf <name>] distribute-list …

configure router rip [vrf <name>] redistribute …

configure snmp-server community

Parameters

[<access-list-

number>]

The number assigned to the access list. Valid values are 1-99 for Standard lists and 100-199 for Extended lists.

Arris C4C User Manual

Questions and Answers: