Arris C4C - Configure Interface Cable-Mac;Cable Dsg Mode

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1523
configure interface cable-mac * cable dsg mode
Purpose
Enables support on the designated cable-mac for DOCSIS 3.0 DSG provisioning.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac> cable dsg mode <30docsis_support | 20docsis_support>
configure interface cable-mac <mac> cable dsg mode no
Supplemental
Information
This command will fail unless the cable-mac is first taken out of service. Also, multicast forwarding by DSID is a pre-requisite for
this command. To enable mcast-fwd-by-dsid, use configure interface cable-mac * cable mcast-fwd-by-dsid (page 1539)
If the cable-mac is configured to support DOCSIS 3.0 DSG, use the no option to return to DOCSIS 2.0 mode.
Parameters
<mac>
The MAC identifier
<30docsis_support
|
DSG supports DOCSIS 3.0 (uses DSID)
20docsis_support>
DSG supports DOCSIS 2.0 or earlier (does not use DSID)