Arris C4C - Configure Interface Gigabitethernet Ip Ospf Authentication Key-Chain

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1753
configure interface gigabitethernet * ip ospf authentication key-chain
Purpose
Specifies the set of keys that can be used on this interface.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] ip ospf authentication key-chain <name>
configure interface gigabitethernet <slot>/<port>[.<0-254>] ip ospf authentication key-chain [<name>] no
Supplemental
Information
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To disable OSPF authentication key-chain, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number.[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<name>
Name of the key chain used on this interface