Arris C4C - Command Summary

Chapter 34: Internet Protocol Detail Record
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 968
service: cpe
method: adhoc
data-ack-window: 200
data-ack-timeout: 60
Collectors
(P = primary, A = active) data records this collector
priority IP address during recent activity (max 4)
-------- --------------- ------------------------------
1 10.1.2.1 0
2 10.1.2.2 0
Recent activity (max 4)
data records this
start stop adhoc session
-------------------- -------------------- -----------------
session-id: 4
service: cpe
method: event
data-ack-window: 200
data-ack-timeout: 60
evt-pace-gap: 0
ollectors data records this collector
(P = primary, A = active) exported--------------------------------
priority IP address start stop change
-------- --------------- ------------ ------------ ------------
1 10.1.2.1 0 0 0
2 10.1.2.2 0 0 0
Report Cycle Set 1 data records this report cycle
exported--------------------------------
start interval start stop change
----- -------- ------------ ------------ ------------
00:00 15 0 0 0
Note: Next to the displayed collector priority are status flags of P and A. The P flag identifies the current primary collector.
The A flag identifies a connected or active collector.
Note: If the simplex RSM resets or a duplex RSM switchover occurs, the IPDR counts are zeroed out.
Command Summary
In summary, IPDR configuration and show commands are categorized as follows:
 Common Commands
 DOCSIS 2.0 Mode Commands
 DOCSIS 3.0 Mode Commands
Common Commands — Common commands are listed as follows: