Arris C4C - Configure Interface Link-Aggregate Ip Address

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1839
configure interface link-aggregate * ip address
Purpose
Creates the virtual interface and assigns the IP address and mask of the virtual interface associated with the default route.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ip address <ip addr> <mask> [secondary]
configure interface link-aggregate <0-9[.0-254]> ip address [<ip addr>] [<mask>] [secondary] no
Supplemental
Information
To deletes a virtual router interface from the specified virtual router, use the [no] option of the command. All primary and secondary
IP addresses for the interface are also deleted if a [secondary] is not specified. If a [secondary] is specified, then only the secondary
IP address/mask is deleted and the virtual interface remains.
Note: Some subnets are reserved for CMTS Internal Processor Communications (IPC). No interfaces may be configured for the
following subnets:
100.0.0.x 100.0.1.x 100.0.2.x
1.1.0.x 1.1.1.x
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<ip address>
The IP address of the interface
<mask>
The IP mask associated with the interface
[secondary]
Secondary IP address or mask