Arris C4C - Configure Interface Loopback Ip Ospf Cost

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1944
configure interface loopback * ip ospf cost
Purpose
Defines the OSPF cost to reach the loopback interface. No other OSPF parameters are configurable.
Default Access Level
15
Command Syntax
configure interface loopback <0-15> ip ospf cost <cost>
configure interface loopback <0-15> ip ospf cost [<cost>] no
Supplemental
Information
To disable the loopback interface, use the no option.
Parameters
<0-15>
The Loopback interface number. Valid range is 0 to 15.
<cost>
The cost to reach the loopback interface. Valid range is 0-65535.
Related Commands
configure interface loopback * ip address (page 1942)
configure interface loopback * isis wide-metric (page 1953)
show ip ospf interface (page 2871)