Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2150
configure ipv6 state searching cable unicast
This command controls how many unicast Neighbor Solicitation attempts to try while doing Neighbor Discovery before switching to
sending multicast Neighbor Solicitations for IPv6 addresses where the MAC/IP binding was previously known. Previously known
MAC/IP bindings will be determined from data stored in the MACDB. The total number of unicast and multicast ARPs to send before
switching to the not-present state is limited by the configure ipv6 nd state searching max-number command.
configure ipv6 nd state searching cable unicast <0-65535d
configure ipv6 nd state searching cable unicast no
Default value = true.
To reset the maximum number to the default value, use the no option.
Parameters
Unicast Neighbor Solicitation attempts. Default value = 0 (zero).
To Next Page
Loading...
