Arris C4C - Configure Cable Max-Qos-Active-Timeout

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1365
configure cable max-qos-active-timeout
Purpose
Configures the maximum QoS Active Timeout the C4 CMTS is willing to allow.
Default Access Level
15
Command Syntax
configure cable max-qos-active-timeout <0-65535>
Supplemental
Information
Note: If DSx DQoS VoIP is enabled, the active timeout should be set at 30 seconds. Increasing the default value or setting the value
to 0 (which represents infinity) is not recommended. The default values serve as a precaution for freeing resources in the event that
any device or transmission path in the network does not perform as required.
This command is for DSx DQoS; it has no effect on PacketCable.
Parameters
<0-65535>
Maximum QoS active timeout allowed in seconds. Default is 30 seconds.