Arris C4C - Configure Interface Gigabitethernet Ip Rip Authentication Key

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1772
configure interface gigabitethernet * ip rip authentication key
Purpose
Sets the authentication key.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] ip rip authentication key <keychain1>
configure interface gigabitethernet <slot>/<port>[.<0-254>] ip rip authentication key [<keychain1>] no
Supplemental
Information
Every RIP message sent on this interface will contain this key and every incoming message received will be validated based on it
having this key.
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To reset the authentication key, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<keychain1>
A 1-16 character text string used for authentication.