Arris C4C - Configure Interface Gigabitethernet Ipv6 Ospf Dead-Interval

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1805
configure interface gigabitethernet * ipv6 ospf dead-interval
Purpose
Sets the interval at which hello packets must not be seen before neighbors declare the router down.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf dead-interval <1-65535>
configure interface gigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf dead-interval [<1-65535>] no
Supplemental
Information
To disable, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number}.
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<1-65535>
Dead interval in seconds.