Arris C4C User Manual

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2114
configure ipv6 nd state searching cable multicast
Purpose
This command controls whether multicast Neighbor Solicitation packets can be sent for IPv6 addresses where the C4 CMTS has no
stored knowledge about a MAC/IP binding (IPv6 addresses that were never stored in the MACDB or have stale MAC aged out of the
MACDB.) The total number of multicast Neighbor Solicitations to send before switching to the not-present state is also limited by the
configure ipv6 nd state searching max-number command.
Default Access Level
15
Command Syntax
configure ipv6 nd state searching cable multicast
configure ipv6 nd state searching cable multicast no
Supplemental
Information
Default value = true.
To reset the maximum number to the default value, use the no option.
Parameters
global-max-rate <0-
65535>
Maximum ICMP transmit rate for all non present IPv6’s
max-number <0-
65535>
Maximum number of ICMP6s sent in this state
rate-limit <100-
86400000>
Minimum time, in msec, between ICMP6’s

Arris C4C Specifications

General

Brand	Arris
Model	C4C
Category	Control Unit
Language	English