Arris C4C - Configure Interface Tengigabitethernet Ip Ospf Dead-Interval

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1986
configure interface tengigabitethernet * ip ospf dead-interval
Purpose
Sets the interval at which hello packets must not be seen before neighbors declare the router down.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip ospf dead-interval <interval>
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip ospf dead-interval [<interval>] no
Supplemental
Information
To disable OSPF dead-interval, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<interval>
Dead interval in seconds from 0 to 2147483647