Arris C4C - Show Isis Neighbor

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2951
show isis neighbor
Purpose
Displays Connectionless Network Service (CLNS) neighbor adjacencies.
Default Access Level
1
Command Syntax
show isis neighbor [detail]
Supplemental
Information
Note: If the connected router does not support MT IS-IS, the protocol will display IS-IS in the above output. If the neighbor row says
‘IS-IS’, it only indicates that the remote IS is using regular IS-IS TLVs on that interface. The CMTS can still send MT TLVs based on its
own system/interface configuration. The CMTS’s MT support can be verified using the show isis protocol command.
Parameters
[detail]
Displays detailed neighbor information.