Arris C4C - Configure Banner Login

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1252
configure banner login
Purpose
Configures the login banner.
Default Access Level
15
Command Syntax
configure banner login {<character> <text> <character>}
configure banner login no
Supplemental
Information
Note: The configure banner command behaves differently on the command line than it does in the running-config.
To clear the login banner, use the no option.
Parameters
<character>
Where <character> is the delimiting character used to begin and end the message. Recommended characters could include but are
not limited to: @ # $ % ^ & * ~ \ /.
<text>
The information you define as the message. Maximum is 100 lines.
Related Commands
configure banner motd (page 1253)