Arris C4C - Configure Snmp-Server Host

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2545
configure snmp-server host
Purpose
Specifies the recipient (SNMP manager) of an SNMP trap or informs notification.
Default Access Level
15
Command Syntax
configure snmp-server host <ip address> [udp-port <port> [notification type <traps | informs>] [version
<v1 | v2c | v3>] [rowstatus <rowstatus>] [timeout <timeout>] [retry <number>] [notify-filter
<std-filter-profile|userdefined-filter-profile>] [taglist <value>] [tparam <value>] [mask <targetaddr
mask>] [mms <max-message-size>]
configure snmp-server host <ip address> [udp-port <port> [notify-filterstd-filter-profile |
userdefined-filter-profile>] no
Supplemental
Information
To remove the recipient (SNMP manager of an SNMP trap or informs notification, use the no option.
Parameters
<ip address>
The target IP address of the trap/inform receiving host in nnn.nnn.nnn.nnn format.
[udp-port <port>]
The User Datagram Protocol (UDP) port number of the host to use.
[notification type
<traps | informs>]
Type of notification to be sent to the host. You can specify either traps or informs. If no type is specified, all notifications are sent.
[version <v1 | v2c |
v3>]
SNMP version
[rowstatus
<rowstatus>]
Row status of the notification receiver. Valid range is 1-6
[timeout
<timeout>]
The time interval that SNMP entity waits for the Informs acknowledgement.
[retry <number>]
The number of retries attempted when SNMP Informs acknowledgement is not received. Valid range is 0-255