Arris C4C - Configure Cable Dsg Vsplist

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1264
configure cable dsg vsplist
Purpose
Adds a piece of vendor-specific settings to a set of vendor-specific information which is grouped to be transmitted together. Multiple
vendor values may be added/deleted for the same vendor oui with repeated calls to the command providing the same
<vendorsetid>. Multiple vendors may be added to the same set by repeating the command with the same <vendorsetid> but with
different oui values.
Default Access Level
15
Command Syntax
configure cable dsg vsp-list <0-4294967295> [index <0-4294967295>] [oui <oui>] [value <vendorvalue>]
configure cable dsg vsp-list <0-4294967295> [index <0-4294967295>] [oui <oui>] [value <vendorvalue>] no
Supplemental
Information
Multiple vendor values may be added/deleted for the same vendor oui with repeated calls to the command providing the same
<vendorsetid>. Multiple vendors may be added to the same set by repeating the command with the same <vendorsetid> but with
different oui values.
To remove the vendor set or entry from the vendor set, use the no option of the command.
Parameters
<0-4294967295>
Identifier of the vendor set to be associated with the downstream interface.
[index <0-
4294967295>]
When combined with the vendorsetid, it uniquely identifies an entry on the vsp-list. Valid numbers are any unsigned integer values.
[oui <oui>]
Vendor assigned Organization Unique ID (3 hexidecimal octets)
[value
<vendorvalue>]
Up to 50 hexidecimal octets containing the vendor-specific information to be sent.