Arris C4C - Сonfigure Interface Cable-Downstream Cable Dsg Vsp-List

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1476
configure interface cable-downstream * cable dsg vsp-list
Purpose
Associates the vendor specific parameter data represented by the <vendorsetid> to the interface represented by the
<slot/connector>. The vendor specific parameter data represented by the <vendorsetid> will be included in the DCD message sent
on the given downstream interface.
Default Access Level
15
Command Syntax
configure interface cable-downstream <slot/port> cable dsg vsp-list <vendorsetid>
configure interface cable-downstream <slot/port> cable dsg vsp-list [<vendorsetid>] no
Supplemental
Information
To remove the vendor specific parameter list from a downstream, use the no option.
Parameters
<slot>
The chassis slot in which the targeted downstream Cable Access Module resides. Valid range for the C4 CMTS is 0-15; valid range for
the C4c CMTS is 10-15.
<port>
The downstream port.
<vendorsetid>
Identifier of the vendor set to be associated with the downstream interface.
Related Commands
show cable enable-trap (page 2649)