Arris C4C - Configure Router Rip Passive-Interface

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2514
configure router rip passive-interface
Purpose
In order for an interface to receive and process RIP messages but not advertise its routes, system administrators can set an interface
to operate in passive mode.
Default Access Level
15
Command Syntax
configure router rip passive-interface {cable-mac <mac> | default | gigabitethernet <slot/port> | link-
aggregate <0-9[.0-254]> | tengigabitethernet <slot/port>}
configure router rip passive-interface {cable-mac <mac> | default | gigabitethernet <slot/port> | link-
aggregate <0-9[.0-254]> | tengigabitethernet <slot/port>} no
Supplemental
Information
To disable the RIP passive interface previously set, use the no option.
Parameters
cable-mac <mac>
Cable-mac interfaces. Valid range is 0-415.
default
Sets all RIP enabled interfaces to be passive
gigabitethernet
<slot>/port>
RCM slot number/gigabitEthernet port number.
Valid range for the C4 CMTS is <17-18>/<0-9>
Valid range for the C4c CMTS is <17>/<0-9>
link-aggregate
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
tengigabitethernet
<slot>/port>
RCM slot number/tengigabitEthernet port number.
Valid range for the C4 CMTS is <17-18>/<10>
Valid range for the C4c CMTS is <17>/<10>