Chapter 22: Channel Bonding
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 712
show cable modem AC-Power-Lost
The following is an example of the output:
Interface DOC
(DS-US) Mac Bonded State SIS Qos CPE MAC address IP Address
------------- ----- ------ ----------- --- ------------- --- --------------- ---------------------
5/2-13/2 1 ac1x1 Operational 3.0 0/0 1 001d.d578.db32 10.138.31.239
Total Oper Disable Init Offline
---------------------------------------------------------
Found 1 1 0 0 0
A more general command that displays the modems that are in Power Save Mode:
show cable modem
Interface DOC
(DS-US) Mac Bonded State SIS Qos CPE MAC address IP Address
------------- ----- ------ ----------- --- ------------- --- --------------- --------------------
5/0-13/0 1 8x4 Operational 3.0 0/0 0 001d.ce77.1cca 10.138.31.236
5/0-13/2 1 8x4 Operational 3.0 0/0 0 001d.cf1e.4934 10.138.31.237
5/6-13/3 1 8x4 Operational 3.0 0/0 0 cca4.624b.bf02 10.138.31.232
5/2-13/2 1 ac1x1 Operational 3.0 0/0 1 001d.d578.db32 10.138.31.239
5/7-13/1 1 8x4 Operational 3.0 0/0 1 001d.cdc3.db1d 10.138.31.246
Total Oper Disable Init Offline
---------------------------------------------------------
Total 5 5 0 0 0
Observability
The C4/c CMTS provides visibility to modems which have not fully registered on all channels for which the topology would
allow. Use the following commands:
show cable modem detail
show cable modem bonded-impaired
Logging — The C4/c CMTS has the capability to enable a debug syslog message which will generate a log message
whenever any CM-STATUS message is generated by a modem.
The debug enable mechanism is configure logging debug cm-status. The following are samples of these messages:
To Next Page
Loading...
Need help?
General
