Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1251
configure autorecovery
Sets autorecovery to on or off. If no parameter is specified, the current autorecovery status will be displayed.
configure autorecovery [<on | off>]
All removable chassis cards (modules) are designed to attempt to recover automatically in response to a failure. This is called
autorecovery, and it is enabled by default. At times development or test engineers may use this command to disable autorecovery in
order to analyze difficult problems.
Note: Autorecovery is required for proper system operation. Turning it off can result in incorrect system operation. Tech Support
should be involved any time this command is used on a system.
Parameters
Sets the autorecovery to on or off.
To Next Page
Loading...
