Arris C4C - Сonfigure Interface Cable-Mac Isis Authentication Key-Chain

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1675
configure interface cable-mac * isis authentication key-chain
Purpose
Configures the IS-IS authentication for LSPs.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac[.s]> isis authentication key-chain <name> [<level-1 | level-2>]
configure interface cable-mac <mac[.s]> isis authentication key-chain [<name>] [<level-1 | level-2>]
no
Supplemental
Information
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To reset the circuit type, use the no option.
Parameters
<mac[.s]>
The MAC identifier and optional sub interface.
<name>
Name of the key-chain
[<level-1 | level-2>]
Specifies the type of adjacencies to be formed on this interface. Valid range is level-1 or level-2.