Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1857
configure interface link-aggregate * ip ospf authentication key-chain
Specifies the set of keys that can be used on this interface.
configure interface link-aggregate <0-9[.0-254]> ip ospf authentication key-chain <name>
configure interface link-aggregate <0-9[.0-254]> ip ospf authentication key-chain [<name>] no
Note: All commands that include key-chains required that the key-chain already exists before the command is executed. In addition,
the key-chain should not be deleted until after the command(s) that reference it have been reset with the "no" command.
To disable OSPF authentication key-chain, use the no option.
Parameters
LAG identifier <lag[sub interface]>
Name of the key chain used on this interface
To Next Page
Loading...
Need help?
General
