Arris C4C - Interface Cable-Mac;Cable Downstream-Bonding-Group;Cable-Downstream

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1517
configure interface cable-mac * cable downstream-bonding-group * cable-
downstream
Purpose
Defines the downstream channels to be used in the bonding group. All the channels must be within one MAC domain.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac> cable downstream-bonding-group <int> cable-downstream <slot/port>
configure interface cable-mac <mac> cable downstream-bonding-group <int> cable-downstream <slot/port> no
Supplemental
Information
Note: There can be multiple downstreams specified by designating a range of downstream ports.
To remove the channel from the bonding group channel set, use the no option.
Parameters
<mac>
The MAC identifier. Valid numbers are 0-415.
<int>
Static bonding group identifier. Valid range is 1-65535.
<slot>
The chassis slot in which the targeted downstream Cable Access Module resides. Valid range for the C4 CMTS is 0-15; valid range for
the C4c CMTS is 10-15.
<port>
The downstream port.
Related Commands
show cable bonding-group-status (page 2637)