Arris C4C - Configure Interface Cable-Upstream Cable Relay-Agent-Option Circuit-ID

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1715
configure interface cable-upstream * cable relay-agent-option circuit-id
Purpose
Enables the relay agent circuit ID sub-option on the specified channel.
Default Access Level
15
Command Syntax
configure interface cable-upstream <slot/ch[.0]> cable relay-agent-option circuit-id <mac-ifindex | text
<word> | hex <word> |us-ifindex>
configure interface cable-upstream <slot/port[.0]> cable relay-agent-option circuit-id <mac-ifindex |
text <word> | hex <word> |us-ifindex> no
Supplemental
Information
To disable upstream agility on a specified upstream channel, use the no option.
Parameters
<slot/ch[.0]>
The upstream slot/channel[.logical channel]. It will assume lc=0 if needed and not supplied.
<mac-ifindex |
Indicates that the 4 byte MAC ifIndex is used for the circuit ID relay sub-option.
text <word> |
ASCII string to be used in the sub-option, 32 characters max.
hex <word> |
Hex string to be used in the sub-option, 64 characters max.
us-ifindex>
Indicates that the 4 byte upstream channel ifIndex is used for the circuit ID relay sub-option.