Arris C4C - Configure Cable Modify-Primary-Ds-Rcc

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1393
configure cable modify-primary-ds-rcc
Purpose
Enables modifying primary downstream channel in RCC of Reg-Rsp-MP.
Default Access Level
15
Command Syntax
configure cable modify-primary-ds-rcc
configure cable modify-primary-ds-rcc no
Supplemental
Information
To disable modify-primary-DS-RCC, the user must also disable selecting the DS-RCC based on DS channel load.
This can be achieved by one or more of the following methods:
- turning off dynamic load balancing for the Mac-Domain with:
configure cable fiber-node <abc> cable-mac <n> load-balance enable no
- or by turning of dynamic load balancing for all Mac-Domains using the default group
configure cable load-balance general-group-defaults enable no
- or by assigning a CM to a policy or restricted load balance group that is disabled
Related Commands
configure cable fiber-node * cable-mac * load-balance enable (page 1268)
configure cable load-balance general-group-defaults enable (page 1339)