Arris C4C - Configure Interface Tengigabitethernet Ip Igmp Static-Group

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1980
configure interface tengigabitethernet * ip igmp static-group
Purpose
Statically adds membership to an IP multicast group on an IP virtual interface.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip igmp static-group <group> [source
<domain-name | source-ip>]
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ip igmp static-group <group> [source
<domain-name | source-ip>] no
Supplemental
Information
To remove membership to an IP multicast group on an IP virtual interface, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<group>
Multicast group IP address.
<domain-name>
Qualified domain name
<source-ip>
IPv4 address