Arris C4C - Configure Cable Multicast Qos Group;Group-Qos;Session-Range Source

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1407
configure cable multicast qos group * group-qos * session-range * source
Purpose
Configures the destination IP multicast group address and network mask length for this QoS group.
Default Access Level
15
Command Syntax
configure cable multicast qos group <0-4294967295> session-range <A.B.C.D/bits> source <address/bits>
configure cable multicast qos group <0-4294967295> session-range [<A.B.C.D/bits>] source
[<address/bits>] no
Supplemental
Information
The group-qos parameter must have been previously set for it to be omitted in this command.
To remove the destination IP multicast group address and network mask length for the specified QoS group, use the no option.
Parameters
<0-4294967295>
Group Configuration (GC) record ID
<A.B.C.D/bits>
Prefix of a range of destination IP multicast group addresses.
<A.B.C.D/pfx-len>
Prefix of a range of destination IP multicast group addresses.
Related Commands
show cable multicast qos group (page 2730)