Arris C4C - Configure Interface Tengigabitethernet Ipv6 Enable

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2013
configure interface tengigabitethernet * ipv6 enable
Purpose
Enables the Ethernet interface for IPv6 processing and creates the default link-local address.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 enable
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 enable no
Supplemental
Information
To remove all IPv6 addresses from the interface, use the no option. If there is no IPv4 configuration, this command removes all layer-
3 configuration.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]