Arris C4C - Configure Interface Cable-Mac;Ip Address

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1592
configure interface cable-mac * ip address
Purpose
This command assigns an IP address to the CAM interface and determines its DHCP policy. Secondary IP addresses become
candidates for the dhcp-giaddr field if and only if the keywords secondary and dhcp-giaddr are both used.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac[.s]> ip address <ip addr> <mask> [secondary dhcp-giaddr [cpe | mta |
ps | stb]]
configure interface cable-mac <mac[.s]> ip address [<ip addr>] [<mask>] [secondary dhcp-giaddr [cpe |
mta | ps | stb]] no
Supplemental
Information
Note: Some subnets are reserved for C4 CMTS Internal Processor Communications (IPC). No interfaces may be configured for the
following subnets:
100.0.0.x 100.0.1.x 100.0.2.x
1.1.0.x 1.1.1.x
To disable the secondary DHCP policy, use the no option.
Parameters
<mac[.s]>
The MAC identifier and optional sub interface.
<ip addr>
IP address
<mask>
Local host mask
[secondary dhcp-
giaddr]
Gateway IP of DHCP server. Can only be used in conjunction with [secondary] keyword
[cpe |
Regular CPE device secondary DHCP giaddr
mta |
MTA device secondary DHCP giaddr
ps |
CableHome PS devise secondary DHCP giaddr
stb]
DSG STB device secondary DHCP giaddr