Arris C4C - Configure Arp State Not-Present Max-Time

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1233
configure arp state not-present max-time
Purpose
Sets the maximum amount of time an ARP cache entry can be in the noPresent state. When the limit is exceeded, the ARP cache
entry transitions to the searching state, unless the notPresent minimum time (set by the configure arp state not-present min-
time has not been reached.
Default Access Level
15
Command Syntax
configure arp state not-present max-time <time>
configure arp state not-present max-time [<time>] no
Supplemental
Information
To reset the time to the default value, use the no option
Parameters
<time>
Rate in packets/second for ICMPs. Range is 1 to 604,8000 seconds and the current default is set for 3 seconds.
Related Commands
configure arp state not-present max-number (page 1232)
configure arp state not-present rate-limit (page 1235)
configure arp state searching max-number (page 1239)