Arris C4C - CLI Commands for Multicast

Chapter 25: Multicast
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 792
CLI Commands
The table below lists the commands that are directly related to the multicast feature. A brief explanation of the purpose of
each command is included.
Table 98. CLI Commands for Multicast
Purpose
CLI Command
Enable [disable] IGMP on the interface
Change the IGMP router version number
for an interface.
configure interface cable-mac <mac>.<subif> ip igmp [no]
configure interface tengigabitethernet <slot>/<port>.<subif> ip igmp
[no]
configure interface gigabitethernet <slot>/<port>.<subif> ip igmp
[no]
configure interface [ten]gigabitethernet <slot>/<port>.<subif> ip
igmp version <number>
IGMP host commands.
configure interface cable-mac <mac>.<subif> ip igmp host-robustness
<int>
configure interface cable <WORD> ip igmp host-robustness <int>
configure interface cable <WORD> ip igmp host-version <int>
configure interface cable <WORD> ip igmp join-group <A.B.C.D> [no]
configure interface cable <WORD> ip igmp join-group <A.B.C.D> source
<A.B.C.D> [no]
Set the static IGMP router joins for Layer3
(Layer3 joins must include the
subinterface.)
configure interface cable-mac <mac>.<subif> ip igmp static-group
configure interface cable <WORD>.<subif> ip igmp static-group
configure interface gigabitethernet <WORD>.<subif> ip igmp static-
group
configure interface tengigabitethernet <WORD>.<subif> ip igmp
static-group
Sets the membership tracking
functionality to be used internally.
configure interface cable <slot/mac>.subif ip igmp multicast-static-
only
configure interface cable-mac <mac>.<subif> ip igmp multicast-
static-only
To set proxy memberships from one
interface to another
configure interface <int> ip igmp proxy-interface <int>
To change the IGMP version of the
router/querier
configure interface cable-mac <mac>.<subif> ip igmp version
<version>