Chapter 41: Logging
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1069
stop = to enable closed-loop feedback throttling
all = to enable complete throttling of all C4/c CMTS events
interval = to set the time during which the trap threshold applies
threshold = to set the number of trap and Syslog events to be transmitted per interval before
throttling
Use the following command to transmit the trap and Syslog messages without regard to threshold settings:
configure logging throttle no
Event Throttling Example 1
Use the following series of commands to view existing throttle settings, configure a throttle which inhibits all messages if
the message rate exceeds 100 messages within 90 seconds, and verify that the change was implemented:
show logging throttle
configure logging throttle threshold 100
configure logging throttle interval 90
configure logging throttle stop
show logging throttle
Event Throttling Example 2
Use the following series of commands to view existing throttle settings, configure a throttle which inhibits all SNMP and
Syslog messages, and verify that the change was implemented:
show logging throttle
configure logging throttle all
show logging throttle
Event Throttling Example 3
Use the following series of commands to view existing throttle settings, set the throttle to allow all SNMP and Syslog
messages, and verify that the change was implemented:
show logging throttle
configure no logging throttle
show logging throttle
To Next Page
Loading...
